Would you like to react to this message? Create an account in a few clicks or log in to continue.


 
HomeSearchLatest imagesRegisterLog inThe Airsoft Sniper

 

 Possible BAR-10 setup

Go down 
2 posters
AuthorMessage
aveenvp
Major
Major
aveenvp


Posts : 769
Join date : 2009-01-05
Age : 30
Location : Baltimore, MD (USA)

Possible BAR-10 setup Empty
PostSubject: Possible BAR-10 setup   Possible BAR-10 setup Icon_minitimeWed Jul 22, 2009 4:11 pm

I might put in the following:

M150 spring
Reinforced spring guide



It's not much, but I'm a little short on cash right now. This is sort of a "until further notice" upgrade set. I don't plan on firing it a ton, so I figure this would do for now. Any opinions?
Back to top Go down
sticks.13
Moderator



Posts : 1931
Join date : 2008-02-10
Age : 32
Location : C-BUS, Ohio

Possible BAR-10 setup Empty
PostSubject: Re: Possible BAR-10 setup   Possible BAR-10 setup Icon_minitimeWed Jul 22, 2009 7:01 pm

Your sears will break... Probably in the first 100 rounds, if not then by the 500th round you sear box should be a big mess...

400FPS is a good FPS for sniping. It may take a little more skill than the 500fps sniper rifles, but its allot of fun.

sticks
Back to top Go down
aveenvp
Major
Major
aveenvp


Posts : 769
Join date : 2009-01-05
Age : 30
Location : Baltimore, MD (USA)

Possible BAR-10 setup Empty
PostSubject: Re: Possible BAR-10 setup   Possible BAR-10 setup Icon_minitimeWed Jul 22, 2009 7:17 pm

340 fps with .28s, Which is what I use.
Back to top Go down
Sponsored content





Possible BAR-10 setup Empty
PostSubject: Re: Possible BAR-10 setup   Possible BAR-10 setup Icon_minitime

Back to top Go down
 
Possible BAR-10 setup
Back to top 
Page 1 of 1
 Similar topics
-
» My Setup
» new CQB setup
» New CQB setup
» SEAL setup
» My Headwear Setup

Permissions in this forum:You cannot reply to topics in this forum
 :: The Sniper's Nest :: Sniper Rifle Upgrades/Modifications-
Jump to: