sniper_32 Colonel
Posts : 1529 Join date : 2009-01-18 Age : 31
| Subject: Where can I pick up a tamiya tool? Thu Nov 26, 2009 9:35 am | |
| I just odered my rails for my KWA however I don't have a tamiya tool to remove the connector I've seen evike has them but I didnt order from them and ASGI never carries em'. Are there any other ways to take the conector off? or would a RC store have them? | |
|
Lone Wolf General
Posts : 2551 Join date : 2008-07-03 Age : 33 Location : Marietta, GA
| Subject: Re: Where can I pick up a tamiya tool? Thu Nov 26, 2009 12:25 pm | |
| Tamiya connectors are nothing. just two pins that slide into a plastic box.
Just take a small flat head screwdriver and insert it. Then just take a hammer and the pin should pop out from the back. | |
|
sniper_32 Colonel
Posts : 1529 Join date : 2009-01-18 Age : 31
| Subject: Re: Where can I pick up a tamiya tool? Thu Nov 26, 2009 4:05 pm | |
| so insert it in and tap it with a hammer GOTCHA! thanks lone wolf saved me 28-30 bucks | |
|
Lone Wolf General
Posts : 2551 Join date : 2008-07-03 Age : 33 Location : Marietta, GA
| Subject: Re: Where can I pick up a tamiya tool? Thu Nov 26, 2009 4:35 pm | |
| pretty much. its not going to save your connector but if your just removing it who cares?
Btw you put the screw driver head down the side opposite of the wires. If your tapping on the same side as the wire then your doing something wrong. | |
|
sniper_32 Colonel
Posts : 1529 Join date : 2009-01-18 Age : 31
| Subject: Re: Where can I pick up a tamiya tool? Thu Nov 26, 2009 10:18 pm | |
| no no i need the connector though because i have to put it outside my RIS | |
|
Sponsored content
| Subject: Re: Where can I pick up a tamiya tool? | |
| |
|