new aeg protection plan!!!!

this is a little bit of advice to help you to get longer life and better performance out of your new gun.
this is primarily for the all metal guns and metal gearboxs

get some blue loc-tight the removable kind... not the red its permanant (bad)
now fight the urge to rip the gun out of the box and fire 10000 rnds. its hard i know but be strong..

take the gun apart, not completely.. as if you were gonna give it a good cleaning.
take note of all the little screws and pins.. this is what you will need the blue loc-tight for..

loosen (but don't remove) the screws one at a time.. apply a small amount of blue loc-tight..a little bit goes a long way.. retighten the screw snug, so you don't strip the screw head.. do the gearbox screws also.. the pins are easer.. don't remove the pins just apply a little blue loc-tight right on the pin where the metal and pin meet.. allow to dry preferably 24hrs check the loc-tight for drying time.

now you wont have to worry about any of the hardware moving from the viberation of the gun..

its a small thing but one of the wrong screws falling out can cause serious problems..

oh yah using the blue loc-tight means. when you want to upgrade, the hardware is removable..

Good tip Saber,

Also, if you should apply to much and have a problem removing the screws later, a little Distilled Vinegar, or Rubbing Alcohol will usually loosen the Loc Tight enough so that you can remove the screws.